Steelcraft Automotive 71390 BULL BAR - Manual (Page 4)

BULL BAR
2011 FORD EXPLORER
Page 4 of 5 6/17/11 (DP)
Passenger Side Installation Pictured
18"
19"
Passenger side
Middle of bumper/spoiler insert location
pictured from back of bumper
Driver side
Fig 8
Fig 7
Front
Do not cut on this side
(Fig 6) Passenger side pictured with air intake
Factory rivets
Air inlet for scoop
(behind bumper cover)
Move metal clip to here (See Dot)
after cutting OR drill a 1/4" hole and
replace the clip with the included:
(1) 5mm x 25mm Screw
(2) 5mm Flat Washers
(1) 5mm Nylon Lock Nut
Illustrations, diagrams and
measurements provided for
example only. It is the installer's
responsibility to determine exact
cuts/modifications to the vehicle
required for proper installation.