Steelcraft Automotive 180310 RUNNING BOARD - Manual (Page 7)

ALUMINUM VIEWPOINT RUNNING BOARDS
2014 SORENTO
Page 7 of 8 12/4/13 Rev1 (DP)
Passenger Side Installation Pictured
Fig 14
Fig 15
Front
Front
Use clamp to temporarily hold front Bracket
up to pinch weld until final installation
(2) 6mm x 22mm STD
Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts
Mark the Bracket location onto back of pinch
weld. Do not drill until after Running Board is
properly aligned and adjusted. Use clamp to
temporarily hold Support Bracket in place. Do
not drill too close to bottom edge of pinch weld
(2) 6mm x 25mm Hex Bolts
(4) 6mm x 18mm Small Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts
Front
Rear
Fig 16
Fig 17