Steelcraft Automotive 213400 3 ROUND SIDE BAR - Manual (Page 2)

8. Determine passenger and driver side rear Mounting Bracket. Position Mounting Bracket through both
previously inserted Bolt Plates and partially thread (1 ea ) 10mm Nylock Nut and (1 ea ) 10mm Flat Washer
to secure Mounting Bracket (Figure 7).
9. Locate the passenger/right Side Bar and carefully place it onto previously installed Mounting Brackets.
WARNING! Do not slide Side Bar back and forth on the Mounting Brackets; this may damage the finish on
the Side Bar.
10. Align holes on the Side Bar with holes on the Mounting Brackets. Attach Side Bar to Mounting Brackets with
the included (4) 8-1.25mm x 25mm Hex Head Bolt, (4) 8mm Flat Washers, and (4) 8mm Lock Washers
(Figure 8). Do not tighten at this time.
11. Level and adjust Side Bar, and then tighten all hardware at this time now.
12. Repeat Steps 2-11 for driver/left Sidebar
13. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Page 2 of 4 5/1/07
(AM)
10mm x 30mm
Bolt Plate
(Bolt Plate)
10mm Nylock Nut
10mm Flat Washer
10mm x 35mm Bolt
Plate w/ Bent
(Bolt Plate w/ Bent)
10mm Nylock Nut
10mm Flat Washer
Passenger Front
Mounting Bracket
Passenger Front
Support Bracket
Passenger Front Mounting Bracket Shown
Figure 1 Figure 2
Figure 3