Steelcraft Automotive 34070 TAILLIGHT GUARD - Manual

STEELCRAFT
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD PART # T7764
2004 NISSAN PATHFINDER ARMADA
PARTS LIST
(1)- TAILLIGHT GUARD PASSENGER SIDE
(1)- TAILLIGHT GUARD DRIVER SIDE
(2)- SUPPORT BRACKETS
(2)- # 6 x 1/2" SCREWS, (4)- #10 x 1” SCREWS, (4)- #10 FLAT WASHERS
INSTALLING TAILLIGHT GUARD
1) START WITH THE PASSENGER SIDE, OPEN THE REAR LIFT GATE AND REMOVE THE SCREWS SECURING
THE TAIL LIGHT TO THE BODY.
2) CAREFULLY UNSNAP THE TAIL LIGHT UNTIL IT IS FREED FROM THE HOUSING.
3) REMOVE THE EXISTING TORX SCREW FROM THE TAIL LIGHT LANCE LOCATED ON THE CENTER EDGE,
ATTACH THE SUPPORT BRACKET TO THE CENTER EDGE USING THE EXISTING TORX SCREW. (FLAT EDGE).
4) SNAP THE TAIL LIGHT ASSEMBLY BACK INTO BODY.
5) POSITION REAR TAILLIGHT GUARD OVER TAIL LIGHT, MAKING SURE THAT THE MOUNTING BRACKETS
ON THE TAILLIGHT GUARD ARE SEATED WHERE THE TAIL LIGHT SCREWS WERE FORMERLY LOCATED.
6) SECURE ASSEMBLY TO JAMB USING THE # 10 x 1” SCREWS AND # 10 FLAT WASHERS. SUPPORT BRACKET
USE THE # 6 x 1/2” SCREWS.
7) RE-PEAT STEPS 1 THROUGH 6 ON THE DRIVER SIDE.
CUSTOMER SERVICE TOLL FREE (888) 800-ARIES