Steelcraft Automotive 84030 REAR BUMPER GUARD - Manual

INSTALLATION INSTRUCTIONS
96-04 NISSAN PATHFINDER
REAR BUMPER GUARD
Part#:
ASSEMBLY
BEFORE ANY ASSEMBLING CHECK OUT ALL PARTS:
1. Read the whole instruction before beginning.
2. Mount the rear bumper guard holes onto outside of vehicle frame. It necessary do it
by holding the rear bumper guard.
3. Remove the bolts on per side that fasten strap-down bracket.
4. Align the bumper with the over holes and mount it with the existing hardware.
BE AWARE that the wag rear bumper guard designed to accommodate factory hitch
packages. If a factory tow hitch requires the same holes of the rear bumper guard
remove only the bolts needed. Do not remove the whole package. Mount the rear
bumper guard with the M12 bolts an M12 locknuts.
5. Adjust and tight up all the bolts for complete Installation.
NO. Description Cat.No Req.No.
1 Read Bumper 1
2 Hex bolts M12×40 4
3 Nylock nut M12 4
4 Flat Washer 12 8