Teka CC-40 STAINLESS STEEL - Manual (Page 15)

The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
When the sign ‘Saturation of the filters’ is on, the filters
should be cleaned.
After cleaning the filters, simultaneously push “+” and “-”
for at least 3 seconds whereupon the sign will be switched
off.
During cleaning and maintenance work, make
sure the safety instructions are complied with.
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the product
instructions.
• If your kitchen hood is painted, use lukewarm water
and a neutral soap.
• Never use metallic scourers, nor abrasive or corrosive
products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
To remove the filters from their fittings, press lightly on the
locks and then pull them off.
The metal filters can be cleaned by soaking them in hot
water with neutral detergent until the fat dissolves and then
rinsing them under the tap or using special anti-grease
products. They can also be washed in a dishwasher. In this
case, it is advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic surface
(blackening it), although this will not affect its fat retention
capacity.
Once clean, leave them to dry off and then fit them onto
the kitchen hood.
Problem solving
Proceed with the following checks before calling the Technical Service:
Active charcoal filters (Optional)
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air by recycling
it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on the individual
conditions of use. These filters cannot be washed nor regenerated. They must be replaced once their
useful life comes to an end.
GB
Filter saturation indicator “F”
Changing light bulbs
Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp.
• Screw the lamp cover back in.
Problem Possible cause Solution
The kitchen hood does not
work.
The mains cable is not connected to
the network.
There is no current in the network.
Connect the mains cable to the network.
Provide current to the network.
The kitchen hood does not
extract sufficiently or vibrates.
Filters are saturated with fat.
Obstruction in the air outlet.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
The lamps do not light up.
The lamps are blown
The lamps are slack.
Change the lamps.
Tighten the lamps.
Cleaning the hood body
Cleaning and maintenance
Cleaning the metal filters