Teka DW9 59 S - Manual (Page 15)

User instructions
15
START THE DISHWASHER
After carrying out all the operations described above correctly, to start
the dishwasher simply press the START/PAUSE button (4) for a few
seconds until a beep sounds (the PROGRAM STARTED light (5) starts
to flash). The 3-FIGURE DISPLAY (12) will show the duration of the
program in minutes. The duration time is only approximate, because it
depends on the washing conditions (quantity of dishes, water
temperature, etc.), and is also continually updated as the washing
program progress.
The 3-FIGURE DISPLAY (12) shows the estimated duration of the
washing program.
If it is necessary to open dishwasher door during the washing cycle,
there will be a 1-minute delay before the program can be resumed.
After correctly closing the door, press the START/PAUSE button (4)
again. This operation may negatively affective the progress of the
washing cycle.
END PROGRAM
The end of the program is indicated by a short signal acoustic and from
the “End” visual notification on 3-FIGURE DISPLAY (12). By pressing
the PROGRAM SELECTION button (2) the “End” visual signal will
vanish from the display and the dishwasher is ready to continue a new
cycle