Teledyne LeCroy WaveExpert 9000_NRO9000_SDA100G Getting Started Manual - Manual (Page 41)

WaveExpert Getting Started Guide
WE-GS-E Rev A ISSUED: September 2005 39
Many of the menu bar buttons give you access to the same functions as do the front panel
buttons. Refer to this Table of Equivalent Functions.
The control buttons of the scope front panel are logically grouped into analog and special
functional areas. Analog functions are included in the Horizontal, Trigger, and Vertical groups of
control buttons and knobs.
Sometimes you may want to change a value without using the numeric keypad. In that case,
simply touch once inside the data entry field in the scope dialog area (the field will be highlighted
in yellow), then use the A
DJUST
group of buttons and single knob to dial in values into the
selected field.
By default, the control knob makes coarse adjustments (that is, digits to the left of the decimal
point). Press the F
INE
button to adjust digits to the right of the decimal point. To enter
exact values, you can also display a keypad by touching twice inside the data entry field. Then
use the keypad to type in the value. The S
ELECT
button steps through a dialog from one
control to the next.
The following table provides an explanation of the front panel buttons and knobs: