Teledyne LeCroy HDO 4000 Operators Manual - Manual (Page 55)

HDO4000 High Definition Oscilloscope
Persistence Setup
This procedure explains how to set up the persistence display on traces. Persistence can be quickly
added to all traces or applied individually.
T URN O N P ERSISTENCE
1. Access the Persistence dialog by choosing Display > Persistence Setupand touching the Persistence
tab.
2. Check Persistence On.
3. Select the persistence mode: None, Color, or Analog
If you're doing individual setup, repeat the mode selection for each channel, then go to that channel's
tab and make the remaining settings.
4. Optionally, check Show last trace to superimpose the channel trace over the persistence display.
5. Optionally, also change Saturation level and Persistence Time , and enable/disable Dot Joined.
T URN O FF P ERSISTENCE
To turn off the persistence display, access the Persistence dialog and clear the Persistence On checkbox.
922498 Rev B 47