Teledyne LeCroy PCI Express 3.0 Mid-Bus Probe - Manual (Page 31)

Teledyne LeCroy PCIe 3.0 Mid-Bus Probe Installation Guide Version 1.2
31
5.1 Reference Clock Cable
The Reference Clock Cable (PE014UCA-X) connects the Mid-Bus Pod to the DUT so that the pod can
use the clock from the DUT. The cable has a 3-pin micro socket at one end that attaches to a 3-pin
header (0.050” spacing) designed into the DUT, and the other end connects to the Clk In port on the Mid-
Bus Probe Pod.
5.2 Daisy Chain Cable
The Daisy Chain Cable (PE009UCA-X) connects multiple Mid-Bus Pods together so they can share the
same clock. One end of the connector is attached to the Clk Out port of the Mid-Bus Pod supplying the
clock signal, and the other end is connected to the Clk In port of the other Mid-Bus Pod.