Installing the software, Using a usb connection – Teledyne LeCroy Summit T28 PCIe Multi-lane Protocol Analyzer QSG User Manual

Page 3

Advertising
background image

Installing the Software

The PETracer software operates all of Teledyne LeCroy’s PCI Express Protocol Analyzer and Exerciser products and should
be installed on a Microsoft

®

Windows

®

-based host machine. You need to install the PETracer software on the host machine

before attaching the Analyzer to the system.
The minimum requirements for the host machine are:

Microsoft Windows® XP, Windows 7 (x86, x64) Windows 8 (x86, x64), Windows Server 2003, Windows Server 2008
and Windows Server 2012 R2 operating systems

Processor with clock speed of 1 GHz or higher

2 GB of RAM

Hard drive with at least 250 MB of free space for the installation of the software and additional space for storing
recorded data

Display with resolution of at least 1024 x 768, with 16-bit color

USB 2.0 port

In general, the higher the performance of the host machine, the better user experience you get. Please refer to the
Readme notes and Summit T28 User Manual for recommended configurations and additional information. User manuals
for your Teledyne LeCroy PCI Express products can be found in

Start > All Programs > LeCroy > PETracer > PCIe Protocol Suite Documents.

To install the software, follow the steps below:
1. Insert the CD into the CD-ROM drive of the host machine that will control the Analyzer. The installation window opens

and displays links to the software installation, user manuals, application notes, and data sheets.

2. Select Install PCIe Protocol Suite and follow the onscreen instructions. The PETracer software installs automatically

on the host machine’s hard disk. During installation, all necessary USB drivers will be installed.

3. To start the application, launch the PETracer program from the Start menu:

Start > All Programs > LeCroy > PETracer > LeCroy PETracer

Software installation can also be downloaded from the Teledyne LeCroy website.

6

7

Using a USB Connection

To set up the Analyzer using a USB connection:
1. Install PETracer software on the host machine.
2. Connect the Analyzer to the 12-volt DC Adaptor

provided in the box.

3. Connect the USB port to a USB port on the host

machine using a USB cable.

4. Turn on the power switch on the back of the Analyzer.
Note: At power-on, the Analyzer initializes and performs a

self-diagnostic. If failure occurs, call Teledyne LeCroy
Customer Support for assistance.

5. Summit T28 will be recognized by the host machine as

a USB device.

Follow the Microsoft

®

Windows

®

on-screen

Plug-and-Play instructions for the automatic installation
of the Analyzer as a USB device on your analyzing
host machine. (The required USB drivers are included
on the Installation CD and were installed on your
system when you installed the software.)
Click Finish when you see the message that says
“Windows has finished installing the software that your
new hardware requires” and the file has been installed
in your host machine.

8. Start the PETracer software, so you can start working

with Summit T28.

Advertising