Teledyne LeCroy Hot Swapping PCI Cards - Manual (Page 10)

6
Examples
Control for the PCIBX
parallel 1 2 de
set LPT port to write mode
parallel 1 0 63 set address for global register
parallel 1 2 d6 strobe address
parallel 1 2 de return strobe
parallel 1 0 01
set data to global register
parallel 1 2 dc strobe data
parallel 1 2 de return strobe
parallel 1 0 64
set address for on-off register
parallel 1 2 d6 strobe address
parallel 1 2 de return strobe
parallel 1 0 00
set data to turn the board on
parallel 1 2 dc strobe data
parallel 1 2 de return strobe
Using MS-Dos Prompt
1. Change the directory to the location of “Parallel.exe”
2. Type parallel 1 0 80
3. Repeat step 2 as needed changing the offset and data information as needed.
Using Start:RUN command
1. Click on Start on the Windows Task Bar
2. Click on Run
3. Click on browse
4. Change the directory to the location of “Parallel.exe”
5. Select Paralell.exe
6. Click Open
7. After the path display in the run box enter the parameters to be used, as highlight below.