Teledyne LeCroy SAS_SATA Automation API manual - Manual (Page 47)

Automation API for Teledyne LeCroy SAS/SATA Protocol Suite 41
SASAnalyzer Object Teledyne LeCroy
ISASAnalyzer::DoSelfTest
HRESULT DoSelfTest (
[in] int SelfTestType,
[out, retval] int* pnResult)
This function is used to run the self test on the currently connected board and report its
faults and defects.
Parameters
SelfTestType : This parameter specifies the type of the self test. This type can be
one of these numbers:
1 : SELF_TEST_MEMORY
2 : SELF_TEST_CLOCK
3 : SELF_TEST_BUZZER_LED
4 : SELF_TEST_VIRTEX_VIRTEX_BUS_TEST
5 : SELF_TEST_MARVELL
6 :SELF_TEST_VITESSE_VIRTESSE_BUS_TEST
7 : SELF_TEST_VITESSE_EXTERNAL_LOOP_BACK
8 : SELF_TEST_VITESSE_EXPANTION_CARD
0 value for SelfTestType means doing the following tests:
SELF_TEST_MEMORY
SELF_TEST_CLOCK
SELF_TEST_VIRTEX_VIRTEX_BUS_TEST
SELF_TEST_MARVELL
SELF_TEST_VITESSE_VIRTESSE_BUS_TEST
SELF_TEST_VITESSE_EXTERNAL_LOOP_BACK
SELF_TEST_VITESSE_EXPANTION_CARD
Return Value
pnResult A zero value for this parameter shows that the self test has passed
and a non‐zero value shows that the self test failed. When the self
test fails it means that an error or problem has been detected. To
get more information on the detected problem you can view the
Self Test Log file. It is in the User folder of the software.
Remarks
Doing a self test on SELF_TEST_BUZZER_LED and SELF_TEST_VITESSE_EXPANTION_CARD
needs user interaction during test..
Example