Teledyne LeCroy Conquest API Manual - API Manual - Manual (Page 47)

Exerciser Command Parameters
41
The following exerciser commands use vtParam1:
API_EXR_COMMAND_GET_DESCRIPTOR - vtParam1 should be a short variable that
identifies descriptor type. Valid descriptor types are Device Descriptor and Configuration
Descriptor.
API_EXR_COMMAND_SET_ADDRESS - vtParam1 should be a short variable that identifies
new device address.
API_EXR_COMMAND_SET_CONFIGURATION - vtParam1 should be a short variable that
identifies configuration value.
API_EXR_COMMAND_CLEAR_HUB_FEATURE - vtParam1 should be a short variable that
identifies selector type. (Valid selectors are in API Constants.)
API_EXR_COMMAND_SET_HUB_ FEATURE - vtParam1 should be a short variable that
identifies selector type. (Valid selectors are in API Constants.)
API_EXR_COMMAND_CLEAR_HUB_PORT_FEATURE - vtParam1 should be a short
variable that identifues selector type. (Valid selectors are in API Constants.) vtParam2 should
be a short variable that identifies port number.
API_EXR_COMMAND_SET_HUB_ PORT_FEATURE - vtParam1 should be a short variable
that identifies selector type. (Valid selectors are in API Constants.)
vtParam2 should be a short variable that identifies port number.
API_EXR_COMMAND_DATA_OUT - vtParam1 should be a short variable that identifies
endpoint index of selected device index. vtParam2 should be a string variable that identifes
data to be output. This data is in hexadecimal base, and if it is a data block, should be the
data block name. vtParam3 should be a boolean variable that identifies whether data is a
data block item.
API_EXR_COMMAND_DATA_IN - vtParam1 should be a short variable that identifies
endpoint index of selected device index.