Teledyne LeCroy Inspector - Users Manual - Manual (Page 24)

CATC CATC Inspector User’s Manual Version 2.31
20
•
a static bus event (Suspend, Resume, Reset)
•
an external trigger signal input
•
various combinations of the above
Selection of the “Event Trigger” recording mode will enable the “Setup...” button immediately to
its right; clicking on the button will bring up the following dialog:
This dialog box contains four panels and a checkbox; the following examines each of these in
turn...
4.4.1.1.4.1 Packet Events
This panel allows for the selection of a variety of packet types (and, in some cases, contents). The
detection of a packet matching the specified criteria will be interpreted as a trigger event.
PID Type: This is the default event selection (using the dialog box shown above); it permits the
operator to select a particular PID type to act as the Event Trigger. Two of the permitted options
(“IN, OUT, or SETUP” and “DATA0 or DATA1”) combine multiple PID types into one
selection. A checkbox (“Trigger on any PID type NOT selected”) inverts the meaning of the PID
selection: the chosen item will be the only one not interpreted as a trigger event.