Teledyne LeCroy AGPAX User Manual
Page 6
6
JUMPER TABLE
Description
Jumper
Utilization
Current measurement
J3
Outputs to DVM
External power input
J5
Inputs from external power supply
+5V isolation from the system
JP5
On = voltage from system
Off = voltage from External supply
+12V isolation from the system
JP6
On = voltage from system
Off = voltage from External supply
VCC3 isolation from the system
JP7
On = voltage from system
Off = voltage from External supply
VDDQ isolation from the system
JP9
On = voltage from system
Off = voltage from External supply
Disable Mechanical On-Off Switch
SW
On = S1 can control the board
Off = S1 is disabled
Remote On-Off
JP15
Shunt On, Board Id is One
Shunt Off, Board Id is Two
JP16
Factory Use Only
LEDs
There are two sets of LED on the board, green and red. Each LED has a label which Voltage it represents. The green
LED, when lit, indicates presence of the corresponding voltage. The red LED, when lit, represent a short on the
corresponding voltage. Please note that the green LEDs do not indicate if the voltage is at the expected level or not.