Tracer TP-1509 battery pack A03124-3 - Manual (Page 2)

TROUBLESHOOTING THE TP-1509 BATTERY PACK
If the bulb does not light, it indicates low voltage from the power
source, a faulty connection, a faulty battery or the need for bulb
replacement. Refer to the operating instructions packed with the
lamp for full information.
1. Check that the lamp plug is firmly seated in the battery
receptacle.
Disconnect the lamp before doing the following trouble-
shooting!
2. Use a voltmeter to check the battery terminals. Recharge the
battery if necessary. For maximum battery life, recharge the
battery before it registers as low as 10 volts.
3. If the battery does not recharge, disconnect it from the char-
ger. Use a voltmeter to check for proper DC voltage at the
charger output. If the voltmeter registers 13.2 volts or above,
the charger is working properly and the battery should be
replaced.
4. Use a voltmeter to check for DC voltage output at the 12V
plug receptacle. If the battery is fully charged and the
voltage still registers zero, replace the fuse. Simply pull it out
and insert a new one. Use a Buss ATC fuse or a Littelfuse
ATO 257-series fuse of the same amperage supplied with
the TP-1509. Either fuse is available at your local auto parts
store.
If the problem persists, contact your Tracerline distributor
or the Customer Service Department of Tracer Products.
WARRANTY
The warranty policy for the TP-1509 battery pack is provided on
the Certificate of Limited Warranty enclosed separately with
each unit.
NOTE: For assistance of any kind, contact the Customer
Service Department at Tracer Products. In the U.S. and Canada,
call toll-free 1-800-641-1133. Outside the U.S. call 516-333-
1254. Give full details of the difficulty and include the model and
serial numbers of the unit and the date of purchase. If return of
the unit to the factory is deemed necessary, shipping instruc-
tions will be provided. If an estimate of charges for nonwarranty
work or other service work is required, a quote will be furnished
upon evaluation of the unit. Out-of-warranty service work will not
be performed without customer approval.
French
TP-1509
12 Volts, bloc de batteries rechargeables
IMPORTANT
Les instructions de fonctionnement doivent être lues
avant d'utiliser le bloc de batteries rechargeables
TP-1509, 12 volts
.
INTRODUCTION
Le bloc de batteries TP-1509 a été spécialement conçu pour
être utilisé avec les lampes d'inspection « instantanée »
Tracerline
® 12 volts. Le bloc de batteries TP-1509 comprend une
batterie rechargeable 12 V CC, 7.2 A/h et une prise munie de
fusibles intégrée à un boîtier de transport en nylon avec une
courroie d'épaule réglable. La prise 12 volts est utilisée pour
(1,1) -2- A03124-3 Battery pack in progress.indd 6/2/11 12:48 PM (1,1) -2- A03124-3 Battery pack in progress.indd 6/2/11 12:48 PM