Vanguard DMOM-200 - Manual (Page 9)

Operating Procedures DMOM-200™
5
PRETEST SETUP
4.1 Operating Voltages
The DMOM-200
 operating voltages are
selectable between 90-130Vac, 50/60Hz or
210-240, 50/60Hz. Voltage selection is set
by the placement of jumpers on the power
terminal block as listed in Table 3.0 below
and Figures 2.0 and 3.0.
Table 3.0 Voltage Selection
VOLTAGE SELECTION TERMINAL BLOCK JUMPERS
90-130Vac Brown to blue & yellow to green
210-240Vac Blue to yellow
Figure 2.0 90 to 130Vac Jumper Setting
Figure 3.0 210 to 240Vac Jumper Setting
220Vac Jumper Installation
120Vac Jumper Installation