American Power Conversion CTEG4-240MB-5 - Manual (Page 4)

2
Installation
Utility line voltage must be routed to the enclosure. Local, state, federal and/or National Electric
Code (NEC) regulations regarding location, permits and electrical wiring must be adhered to.
Do not operate the power supply where the temperature and humidity are outside the specified limits.
See Specifications in this manual.
Specifications
Environmental Specifications
Operating Temperature
-40º F to 140º F (-40º C to 60º C)
Physical Specifications
Characteristic Specification
Height X Width X Depth 47” x 28” x 18” (119 x 71 x 46 cm)
Weight 70 lbs (32 kg)
Unpacking
Inspect the unit upon receipt. Notify the carrier if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the package contents. The package contains the enclosure, battery cables, connectors and
associated hardware, and product documentation.
CTEG4-240MB-5: (5 cables) 15" black battery jumpers (2); 40" black (1);
80" black (1); 40" red (1)
Installing the Enclosure
1. Install an APC approved concrete pad.
Contact your dealer or refer to the APC Web site, www.apc.com for more information.
2. Secure the enclosure to the pad. Refer to the diagram below.
Place the enclosure on the pad. The holes on the
enclosure must be aligned with the anchor hooks
on the pad, (hardware not included).
This is a general representation of an enclosure
mounted on a pad. Configurations may vary.