Waterstone PLP PULLDOWN FAUCET 5800 - Manual (Page 3)

F
COUNTER
OR SINK
1. 2. 3. 4.
A
B
C
D E
A
C
B
A
B
1. Before connecting supply hoses, flush
supply stops to clear any debris. Place a
bucket underneath stops and run water
for 5 to 10 seconds. Turn water off.
2. Carefully position hot and cold supplies
so they will not interfere with other hoses.
3. Connect supply hoses (A) to supply
stops (B). DO NOT use teflon tape or
plumbers putty. Turn water back on and
check for leaks.
CONNECT THE PULL DOWN SPRAY HOSE CONNECTING SUPPLY HOSES
Connect spray hose (A) to spray
connection hose tube (B).
NOTE – make sure spray hose (A)
and counter balance (C) are free
to slide up and down and are not
in conflict with any plumbing
components or items under sink.
RED FOR HOT
BLUE FOR COLD
H C H C
COMPASS H/C COMPASS C/H FINISH MATCH
Waterstone faucets are designed for 3 different faucet positions.
Handle on left, front and right. Your faucet is configured for the
most common installation (see below). To reverse this and have
the handle positioned on the left, connect the hose for cold
water to the hot supply and the hose for hot water to the cold
supply. This will maintain the relationship of pulling the handle
for hot water or pushing for cold water.
HANDLE ON LEFT HANDLE IN FRONT HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H C
A
B
C D
A B E
E
G
C D F
F
HANDLE POSITION
OPTIONAL DECORATIVE CAPS
(TRADITIONAL ONLY - 3 INCLUDED)
OPTIONAL HOT COLD INDICATOR RING
(CONTEMPORARY ONLY)
1. To remove, place a small standard screwdriver in
the slot at the bottom of metal ring that surrounds
the handle caps. Gently pry the cap from faucet
handle.
2. To replace, position cap and snap in with thumb.
1. To reverse, or remove Hot and Cold Indicator
Ring, unscrew the metal cap, remove ring and flip.
2. Slide ring back onto handle and screw metal
cap back on.