Connecting supply hoses, Cleaning aerator and debris screen – Waterstone BAR FAUCETS 2500 User Manual
Page 4
1. Before connecting supply hoses, flush supply stops to clear any debris. Place a bucket
underneath stops and run water for 5 to 10 seconds. Turn water off.
2. Carefully position hot and cold supplies so they will not interfere with other hoses.
3. Connect supply hoses (A) to supply stops (B). DO NOT use teflon tape or plumbers putty.
Turn water back on and check for leaks.
CONNECTING SUPPLY HOSES
A
B
1. Gently unscrew and remove spout tip (A) by hand.
2. Remove O-ring (B). To remove aerator (C), push with finger from bottom.
3. Thoroughly rinse aerator with water until all debris is removed.
4. Place aerator, then O-ring back into spout tip.
5. Gently screw spout tip, by hand, snuggly back onto spout.
Depending on quality of your household water, the aerator
and debris screen may become clogged. We recommend
cleaning one week after installation, then a minimum of
once of year thereafter. To remove the debris, follow the
steps below.
CLEANING AERATOR AND DEBRIS SCREEN
B
C
A
1.
2.
3.
4.
5.