White’s Electronics M6 - Manual (Page 9)

7
Chapter 3 M6 Quick Start Quick Start
Instructions
With the M6 properly assembled and the
batteries installed, follow the instructions below to
start finding treasures!
Set the Auto Trac ® Toggle to the
"On" position. "▼"
Set the Trigger Switch (under the hand
grip) to the center (Search) position.
Set DISC to " ".
Turn the SENS control clockwise until the
power clicks "ON". Rotate the SENS
control clockwise to "▼".
Lower the search coil to the ground, then
“pump” the coil up and down 2-4" a
couple of times and AutoTrac
® will
automatically balance or track out the
ground mineralization.
Start swinging the search coil in wide
sweeps that overlap each other, as near
to the ground surface as possible, about one
second per foot.
If you experience false signals or constant
beeping or popping and you are not near
common sources of electrical interference,
set TRAC to LOCK and/or reduce SENS
(counterclockwise) slightly and try again.
1
2
3
4
5
6
7
* SPECIAL NOTICE * SPECIAL NOTICE * SPECIAL NOTICE * SPECIAL NOTICE * SPECIAL NOTICE
If you attempt to demonstrate or test the
M6 by waving targets in the air in front of
the search coil, the Auto Trac
® toggle
must be in the Lock position.
When the M6 Auto Trac ® toggle is in the
"On" or "Beach" positions with no
ground present, it will think that the
target IS ground and will attempt to track
it out.
You may, however, demonstrate the fast
ground balancing feature of Trac "On" or
"Beach" by waving or pumping a miner-
alized rock in the air in front of the search
coil.
5
6
2 to 4 inches