White’s Electronics TDI Pro - Manual (Page 8)

8 TDI Pro Owner’s Guide
and recharge the battery. Continuing to use a battery “without the green
light shining” can damage the Lithium Ion Battery. Typically the Lithium
Ion battery will operate the Pulsescan TDI Pro approximately 8 hours per
charge.
Two battery chargers are supplied with the Pulsescan TDI Pro.
1. The Smart Charger (Part Number 509-0040) is used to recharge the
Lithium Ion Battery from a household wall outlet. It has two internal LED
lights that indicate the status of the battery charging cycle.
a. Connect the battery pack to the charger fi rst and then plug the
charger into a household wall outlet.
b. The LED lights in the charger will fl ash RED-GREEN-RED-GREEN.
This is a self-check that indicates the charger and battery are
operating correctly.
c. The RED light then comes on steady to indicate the charger is
charging and the battery is accepting a charge.
d. When the battery reaches a full charge (a minimum of 7 hours),
the red light fades and the green light comes on indicating the
battery is fully charged and ready to use.
e. If the battery is left connected to the charger for an excessive
amount of time, the lights will return to the initial RED-GREEN-
RED-GREEN cycle indicating the system is no longer charging.
First unplug the charger from the wall, and then disconnect the
battery from the charger.
f. Only use the charger indoors, it is not weather proof.