WolfVision VZ-8plus 4 Quick Setup Guide - Manual

www.wolfvision.com Printed in Austria - October 2012
Connect power supply and monitor or projector.
Insert both batteries into the remote control - note polarity.
Raise the arm up and turn the camera to working position.
Before Starting
Quick Setup Guide - First Steps
When the Visualizer is switched on the first time, the Quick Setup Guide will be started automatically on-
screen (visible on HDMI and RGB output). Use the arrow keys to navigate through the menu.
Basic Menu Settings
Language
Select the desired language for the on-screen menu.
Ethernet Settings
The IP-address, Subnet Mask and Gateway IP-address can be set automatically by a DHCP-server or
manually.
Time Settings
The Visualizer offers the possibility to use the internal clock or an external time server (a time valid time
server IP address and internet connection are required).
Power Key
F
Switch the Visualizer on by pressing the POWER key.
Further information is available at and on the supplied CD-ROM. www.wolfvision.com