IEI Integration SPCIE-C2060 v1.01 - Manual (Page 69)

SPCIE-C2060 PICMG 1.3 CPU Card
Page 54
Figure 4-11: DVI-D/USB Kit Installation
Step 3: Mount the DVI-D/USB kit onto the chassis. Once the DVI-D/USB kit is
connected to the board, secure the DVI-D/USB kit bracket to the system
chassis.
4.5.3 SATA Drive Connection
The SPCIE-C2060 Series is shipped with four SATA drive cables. To connect the SATA
drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.