IEI Integration iQ7-US15W - Manual (Page 75)

IQ7 Design Guide
Page 63
Figure 4–29: Jumpers
4.4.1 AT/ATX Mode Selection
Jumper Label: JP8 & SW5
Jumper Type: 6-pin header & switch
Jumper Settings: See
5
Table 4-29 & Table 4-30
Jumper Location: See Figure 4–29
Set both of the jumpers select AT or ATX power mode for the IQ7 Design Guide. AT
power mode limits the system to on/off. ATX allows the system to use various power
saving states and enter a standby state, so the system can be turned on remotely over a
network. The settings on both jumpers should be the same.
JP8 Description
1-2 ATX mode
3-4 AT mode
5-6 No function
Table 4-29: AT/ATX Mode Selection