4 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration IMB-Q670 v2.01 User Manual
Page 74: Eripheral, Evice, Onnections, Figure 4-12: sata drive cable connection, Table 4-6: wake-on lan connector pinouts
IMB-Q670 Micro-ATX Motherboard
Page 60
PIN NO.
DESCRIPTION
Short 1-2
Wakeup Enable (Default)
Short 2-3
Disable
Table 4-6: Wake-on LAN Connector Pinouts
4.4 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.4.1 SATA Drive Connection
The IMB-Q670 is shipped with four SATA drive cables. To connect the SATA drives to the
connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-12.
Figure 4-12: SATA Drive Cable Connection