IEI Integration IMB-H610A - Manual (Page 70)

IMB-H610 Mic ro -ATX Mo th e rb o a rd
P a g e 55
4.4 J u m p e r S e ttin g s
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper. Figure 4-8: Jumper Locations
The jumpers on the IMB-H610 must be set in accordance with the desired configuration
before installation. The jumpers on the IMB-H610 are listed in Table 4-1.
De s c rip tio n La b e l Typ e
AT/ATX power select JATX_AT1 2-pin header
Clear CMOS J_CMOS2 3-pin header
USB power select USB_PWR1,
USB_PWR2
3-pin header
Table 4-1: Jumpers
4.4.1 AT/ATX P o we r S e le c t J u m p e r
J u m p e r La b e l: J ATX_AT1
J u m p e r Typ e : 2-pin header
J u m p e r S e ttin g s : See Table 4-2
J u m p e r Lo c a tio n : See Figure 4-9
The AT/ATX power select jumper specifies the systems power mode as AT or ATX.