Figure 4-19: dual usb cable connection – IEI Integration NOVA-HM551 v1.10 User Manual
Page 82
Advertising
NOVA-HM551 5.25" SBC
Page 68
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2:
Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the NOVA-HM551 USB connector.
Step 3:
Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the NOVA-HM551, connect the cable connectors to
the on-board connectors. See Figure 4-19.
Figure 4-19: Dual USB Cable Connection
Step 4:
Attach the USB connectors to the chassis. The USB 2.0 connectors each of
two retention screw holes. To secure the connectors to the chassis please refer
to the installation instructions that came with the chassis.
Step 0:
Advertising