Audiovox CDC-825 - Manual (Page 10)

9
9
INFRARED SENDER
The wireless signal from the remote control is sent from this lens. For
optimal range and performance of the remote control, always aim the
Sender at the Remote Sensor
bl
on the wired control unit. Do not let your
finger interfere with the signal and make sure the lens does not become
blocked by dirt, dust, etc. If necessary, clean the lens with a soft dry cloth
or cotton swab.
NOTES ON REMOTE CONTROL USE:
The remote control operates on a 3 volt lithium battery (type
CR-2025). Install the battery into the compartment at the bottom of
the remote control, making sure to observe correct polarity (match
“+” side of battery to “+” indication on compartment).
If remote control fails to operate, always check battery condition and
replace if necessary before servicing the unit .
Dispose of batteries properly. Do not heat, disassemble, or throw
batteries into a fire.
Keep the remote control away from areas where it may be exposed
to heat, moisture or sunlight.