IEI Integration VSTAND - Manual

 Align the screw holes on the V-Stand
with the VESA mount screw holes on
the system rear panel.
Ž Insert the four monitor mounting
screws into the four screw holes on
the system real panel. Adjust the V-
Stand to a proper position.
 Tighten until the screw shank is
secured against the rear panel.
 Align the V-Stand screw holes with the
pilot holes on the mounting area. Mount
the V-Stand by inserting the retention
screws into the four pilot holes and
tightening them.
‘
Adjust the V-Stand to have a best
viewing angle to operate the system.
ΠCarefully mark the locations of the four
V-Stand screw holes on the mounting
area. Drill four pilot holes at the
marked locations for the V-Stand
retention screws.
V-Stand - VESA Standard Multi-Mounting Stand
B
A
A
A
B
B