IEI Integration IDDV-6304140A - Manual

Quick Installation Guide
IDDV-6304140A
140W DC/DC
ATX Converter Module
Version: 1.0
5V@10A Max.
3.3V@10A Max.
12V@4A Max.
[email protected] Max.
[email protected] Max.
o Input Voltage: 6VDC to 30VDC
Min. input operating voltage: 5.7V
Max. input operating voltage: 30V
o Min. Power Up Voltage: 8V
o Deep discharged shut down voltage: 10.6V
ABOUT THE IDDV-6304140A
Dimensions: 45mm x 160mm
Environment:
The highly efficient, high-performance 140-watt IDDV-6304140A
DC-to-DC vehicle ATX converter module provides 5V, 3.3V, 12V,
-12V and 5VSB outputs. The IDDV-6304140A is designed for vehicle
PC and receives a wide range of inputs between 6 and 30 VDC. The
IDDV-6304140A is built on an intelligent design and provides
outstanding line and load regulations. The IDDV-6304140A is
capable of sustaining 90% power efficiency.
o Operating temperature: -20°C ~ +85°C
o Storage temperature: -40°C ~ +125°C
Weight: NW: 118g
Power Capacity:
Voltage
Current
(Max.) Ripple
(Vp-p) Line
Regulation
The power module also solves the 5V standby problem by cutting off
the 5VSB rail after an amount of time (defined by jumper settings) to
prevent the battery from draining. When the battery voltage is below
10.7V for more than thirty seconds, the IDDV-6304140A shuts down.
The IDDV-6304140A reactivates again only when the input voltage
is higher than 10.7V.
5V output 10A 50mV 1.5%
3.3V output 10A 50mV 1.5%
12V output 4A 50mV 1.5%
-12V output 0.15A 150mV 1.5%
IDDV-6304140A QIG IEI Technology Corp. Page 1
SPECIFICATIONS 5VSB output 1.5A 150mV 1.5%
Highly compact design
Table 1: Maximum Power Capacity
Smart system on/off control
High efficiency up to 90%
Load down protection
PACKING LIST
Over voltage protection
Over current protection
When you unpack the power module, make sure the
following items have been shipped.
Short circuit protection
Battery voltage monitor
Amplifier on-delay control 1 x IDDV-6304140A ATX converter module
RoHS compliant 1 x QIG (Quick Installation Guide)
IrDA remote control Off (optional) 1 x 20-pin ATX to 20-pin ATX/SATA/HDD cable
(optional)
Electrical Specifications:
o Total output capacity: 140W 1 x Wire to battery and ACC on (optional)