AT&T 1040 - Manual (Page 44)

38
One-touch setup and operation
To dial a one-touch number
This phone comes with one-touch preference
preset to
INTERCOM.
NOTE: To change one-touch preference, see
PREFERENCE on page 35 of this manual.
If one-touch preference is set to INTERCOM:
1. Lift the handset.
-OR-
Press
[ SPEAKER].
-OR-
Press
[HEADSET] and listen for the dial tone.
2. Press the one-touch button.
-OR-
Press [LOWER], then press the one-touch button
for the destination number you want to call. The
screen displays the number as it is dialed.
If one-touch preference is set to TELEPHONE:
You do not need to go off hook and listen for a
dial tone before dialing a one-touch number. You
can simply:
Press the one-touch button.
one-touch button. button.
-OR-
Press
[LOWER], then press the one-touch button one-touch button button
for the desired number to call.
The screen displays the number as it is dialed using
the speakerphone or headset as programmed for
automatic mode. (See
AUTOMATIC MODE on page
39 of the installation guide.)