Lincoln Electric IM10118 POWER WAVE S500 - Manual (Page 12)

A-6 INSTALLATION
POWER WAVE ® S500
A-6
SMAW (STICK) WELDING
Similar to TIG welding a user interface is required for
adjusting the Stick welding settings. A Power Feed
wire feeder can be used as the user interface, or a
K3001-2 (user interface control panel) can be installed
into the power source (Figure A.3). The connection
diagram shown is based on the S-Series user inter-
face (K3001-2). In this diagram the remote control box
is optional.
REMOTE CONTROL BOX
K857
TO POSITIVE (+) STUD
TO REMOTE CONTROL
RECEPTACLE
TO NEGATIVE (-) STUD
ELECTRODE HOLDER KIT
K2394-1 KIT
(INICLUDES GROUND CLAMP)
WORK PIECE
WORK CLAMP
USER INTERFACE
CONTROL PANEL
K3001-2
STICK WITH S-SERIES USER INTERFACE
FIGURE A.3