Master Manufacturing MASTER GARDNER - Manual (Page 2)

Note: Do not return product to the distributor/dealer for warranty work. Call Master
Manufacturing at (800) 864-1649 for any warranty work or replacement parts.
INTRODUCTION
The purpose of this manual is to assist you in the assembly, operation and maintenance of your Master Gardner
sprayer. Please read through this manual completely too fully understand how to operate and maintain your
equipment. This product has been manufactured to provide years of dependable service; proper operation and
maintenance will ensure its dependability. Keep your manual in a safe, convenient place for future reference.
Always mention the model and part number in any correspondence.
ASSEMBLY
The Master Gardner is assembled at the factory with the exception of a few components to protect them from
shipping damage. Follow the steps below to complete assembly:
Hooking up pump to battery source
1.) Remove the sprayer from the carton and gently tip the sprayer upside down onto the tank lid.
2.) Looking underneath the back panel, locate the (2) black two pin connectors. One from the pump and
the other from the wiring harness leading to the battery (neither of these wires should have any labels
on them) Plug these two connectors together securely.
Caution: Do not hook up the red connector labeled “Remote Switch” to anything but the remote
switch. This will cause the fuse to blow.
Handle Assembly
1.) Remove sprayer and components from Carton.
2.) Locate and remove the two bags of components from within the tank. Open the parts bag labeled;
“Acc. Bag” and remove these instructions. Read instructions in their entirety before proceeding.
3.) Slide handle (Item 1, figure A) into lower frame (Item 7, figure A). Adjust handle height to a
comfortable setting for the operator. Adjust handle to align the holes in handle and lower frame closest
to desired setting.
4.) Using the two handle adjustment knobs and bolts (Item 2, figure A), insert bolts through holes in handle
and tighten with knobs.
Front Deflector Nozzle Attachment
Note: If nozzle is assembly is complete proceed to step 4.
1.) Locate the bag labeled Nozzle Assembly.
2.) Insert Nozzle body fitting (Item 7, figure B), through the nozzle bracket (Item 8, figure B), and hold in
place with nozzle body nut (Item 9, figure B) tightened loosely by hand.
3.) Insert nozzle filter (Item 9, figure B) into nozzle body. Place deflector nozzle (Item 11, figure B) into
nozzle nut (Item 12, figure B). Thread nozzle nut with nozzle onto nozzle body fitting and tighten
slightly.
4.) Attach Nozzle bracket to tank (Item 16, figure B) with two screws and washers. Tighten securely.
5.) Locate clear vinyl hose from bottom front of tank. Attach hose to nozzle body fitting attached to front
of tank with hose clamp (Item 17, figure B).
6.) Tighten all nuts and screws securely ensuring the nozzle is pointing directly down towards the ground.
Using the Master Gardner as a Trailer
If the Master Gardner will be used with a garden tractor a trailer tongue can be attached to the sprayer for
towing. A “Remote Switch” is also supplied so the sprayer pump can be remotely operated from the
tractor. If the Master Gardner will be used as a trailer, follow the instructions below:
1.) Locate the remote switch wiring harness from the accessory bag.
2.) Locate the sprayer wiring harness connector near the opening on the bottom of the black pump shield
on the back of the sprayer. The two pin red connector will be labeled “Remote Switch”. Attach the
red two pin connector from the Remote Switch to the red connector on the sprayer.