Otter Outdoors Pro XT 1200 Cottage - Manual (Page 5)

Page 5
7. Position sled (Item 1) as shown in Diagram 7 with curved front to your left. Using front drilling pattern (on back
page) mark two holes for the front frame bracket with a sharp object. Using rear drilling pattern (on back page),
repeat this step for the rear frame bracket.
8. Drill the 4 marked holes using a 5/16 bit.
9. Drill the 3/8 in. hole in center of lip approximately 16 inches from bend in sled. The back wind support bar (Item
5 not shown) is to be propped here. Ref Diagram 7.
Diagram 7
Diagram 8
Item 25 - 5/16 Washer
Item 28 - 1/4 Nylon Hex Lock Nut
10. Bolt frame brackets (Item 3 and Item 4) to sled using holes predrilled in Step 8.
Use appropriate fasteners shown in Diagram 8.
Place front and rear drilling
patterns in these corners.
16 in.
3/8 in.
Hole
1
3
25
28
4
Seat assembly not shown for clarity.