Poly-Tex PlantScape - Manual (Page 2)

Before you start
You will need
Position the product on the mounting surface according to the quantity of purchased panels.
A combination of various designs/models assembly is possible.
Horizontal or vertical assembly of panels is possible using connector (#7306).
Each panel is equipped with an internal drip irrigation system.
You may connect up to 4 units together for 1pressure regulator (#7351).
It is highly recommended to be assisted by a second person in the installation process.
Sort out all parts and check the contents list.
Make sure that screws and wall plug suit the wall compound.
The product must be positioned and fixed on a level surface.
Please be safe during assembly.
To assemble your PlantScape (these items are not supplied)
Attention!
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety
This product should be fixed to the wall as shown in these instructions to ensure its
stability and wind resistance.
Some parts have sharp edges. Please be careful when handling components. Always
wear gloves, eye protection, and long sleeves when assembling or performing any
maintenance on your product.
Do not attempt to assemble on days with strong winds or low temperatures. If using a
stepladder or power tools ensure that you follow the manufacturer’s safety advice.
Care and Maintenance
During Assembly
Low maintenance.
When your product needs to be cleaned, use a mild detergent solution and
rinse with cold clean water. DO NOT use acetone, abrasive cleaners, or other
special detergents to clean the panels.
During assembly you will encounter the information icon, please refer
to the relevant assembly step for additional comments and assistance.
Step 1 : Choose Option 1 or 2 for positioning panels, If Option 1 is chosen, make
sure that external tab is placed between the 2 panels. (See example)
Step 3 : In order to attach the irrigation pipe to connector #7306, place
the edge of the pipe in hot water to soften.
Water inlet connection can be either on top or bottom of the panel according to
water infrastructure/mounting.
You will need approximately 8 Liters of general-purpose compost for 2 panels (4
pockets each). Compost is available at your local garden center
or nursery.
Each box (2 panels) contains a water pressure regulator #7351
Please make sure to connect the water pressure regulator. This will allow constant
and stable irrigation pressure for your plants.
Connecting the panels to an automatic irrigation system is possible.
Step 5 : Please make sure to connect up to 4 units together with
1 pressure regulator (#7351).
Do not cut the pipe unless a final decision has been made on the
mounting location.
EN
8 mm
5/16”
These assembly instructions are suitable for all Palram’s PlantScape designs/models:
Using the PlantScape allows you to grow beautiful plants on your outdoor wall.