Probuilt Professional Lighting Wobblelight User Manual

Important safety instructions, Save these instructions

Advertising
background image

Manufactured by ProBuilt Professional Lighting: 877-707-0800

Thank you for purchasing Wobblelight

®

IMPORTANT SAFETY INSTRUCTIONS

WARNING !!!

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.

SAVE THESE INSTRUCTIONS


This manual contains important safety and operating instructions for Wobblelight

®

portable job site lighting. Before using Wobblelight

®

, please review all of the

following safety instructions carefully and read all labels on the Wobblelight

®

unit.


INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND INJURY TO PERSONS:


WARNING: To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons:

 DO NOT connect Wobblelight

®

to power source until the bulb is installed and the unit is completely assembled.

 Metal halide and halogen bulbs get EXTREMELY HOT immediately upon illumination and can cause burns.

 Bulbs stay hot for an extended period of time after Wobblelight

®

unit has been turned off, and can continue to cause burns.

 DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight

®

unit is disconnected from the power source and the bulb has

completely cooled.

 Not for use in wet locations. DO NOT use Wobblelight

®

where this is potential for exposure to excessive moisture from rain, snow, ice or water spray or

standing water.

 DO NOT leave Wobblelight

®

units operating for extended periods of time in unattended areas.

 Connect

Wobblelight

®

only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current protection.

Any other connection voids warranty.

 Wobblelight

®

is not recommended for use with generators except under emergency situations or when the generator output power is carefully monitored to

stay within +/-10% of 120V.

 Keep away from flammable materials.

 Wobblelight

®

must be operated in the upright position only. DO NOT mount Wobblelight

®

units upside down or restrain them such that they lay on their

side.

 Use only approved extension cords in good condition and of the appropriate type, gauge and length for each application.

Advertising