Qualcraft Lil' Bucket of Safe-Tie - Manual (Page 7)

SPECIFICATIONS:
Materials:
304 Stainless Steel
Materials:
Zinc chromate finished steel
Materials:
Steel (unfinished)
RESUABLE
ANCHOR
TEMPER ANCHOR
SNAPPY
ANCHOR
Materials:
Galvanized Steel
SPANKER ANCHOR
SNAPPY
1-800-466-6385
Warning!
Read instructions before use.
Failure to read and follow
instructions included at time of
shipment can result in serious
personal injury.
Installer must use eight (8) 16d 3½"
nails (incl.) to attach this anchor
through the roof sheathing into a
truss or structural member capable
of holding a 5,000 lb. load.
This product is designed for use
only at the ridge on any pitched
roof. If bracket is deformed due to
impact or wear it must be destroyed
or bent over and covered by
roofing. This is not a permanent or
reusable anchor. it must be bent
over and destroyed after use.
This product meets ANSI Z359.1
and OSHA requirements for a fall
arrest device.
Use of full body harness a nd
deceleration device is
recommended. For more
information please call:
REUSABLE ANCHOR
Guardian Fall Protection
800-466-6385
WARNING!!
Failure to read and follow
instructions included at time
of shipment can result in
serious personal injury!
Installer must use 10 #12 x 2”
fasteners provided.
Replacement screws must be
ordered for each installation.
All fasteners must attach to
rafter. Use only with
compatible equipment.
5,000lb. anchor. Max. capacity
1 person at 310lbs.
Guardian Fall Protection
TEMPER anchors meet OSHA and ANSI standards. Inspect before each use.
Max. worker weight is 310lbs. 5000 lb. load rating with provided screws.
Use only with compatible connectors and use caution when working
around electrical or chemical sources.
Warning: All holes must be used by attaching into the truss.
Follow instructions included with product in shipment from manufacturer
For Pitches steeper than 4/12, 16d galvanized or duplex nails may be used
instead of screws for fall arrest. Always install fasteners into a truss.
Supplied #12x2" fasteners can be used in fall arrest for any pitch.
With 16d galv./duplex nails on 4/12 pitch or less set up in Fall Restraint ONLY.