Qualcraft Guardrail Receiver - Manual (Page 10)

G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
8
For all Guardrail Receivers, fasteners MUST be completely embedded in substrate, and
MUST be those provided by Guardian Fall Protection, or be deemed compatible with
applicable Guardrail Receiver by a Competent Person.
Guardrail Receivers MUST be installed flush against substrate, and must allow guardrail
posts to be positioned perpendicular to work surface.
Substrate MUST be deemed compatible with Guardrail Receivers by a Competent Person.
See the following for model-specific instruction examples and requirements:
#15158
Guardrail post perpendicular to work surface.
(4) Fasteners fully embedded into side wall.
Fasteners must be ¼” x 2“ lag bolts.
#15159 #61027
(5) Fasteners fully embedded into substrate.
Fasteners must be 16d nails or #10 2” screws.
Guardrail post rests flush against side wall when
inserted through Guardrail Receiver.
#15188
(2) 2” x 4” boards inserted vertically
in each Guardrail Receiver, and secured
on each side with compatible fastener.
Midrail installed level across posts,
and halfway between top edge of
guardrail system and work surface.
Toprail installed 42” (+/- 3”)
above work surface.
Toeboard installed in applicable location of Guardrail Receiver.
(6) Fasteners fully embedded into substrate.
Fasteners must be ¼” x 2“ lag bolts.