Qualcraft CB-12 Weld-On Post User Manual
Page 10
Compatibility: When making connections with CB Anchors, eliminate all possibility of roll-out.
Roll-out occurs when interference between a hook and the attachment point causes the hook
gate to unintentionally open and release. All connections must be selected and deemed
compatible with CB Anchors by a Competent Person. All connector gates must be self-closing and
self-locking, and withstand minimum loads of 3,600 lbs. See the following for examples of
compatible/incompatible connections:
Connector
closed and
locked to
D-ring.
OK.
Two or more
snap hooks or
carabiners
connected to
each other.
NO.
Two connectors
to same
D-ring.
NO.
Connector
directly to
horizontal
lifeline.
NO.
Connector
to integral
lanyard.
NO.
Connector
directly to
webbing.
NO.
Application
that places
load on gate.
NO.
Incompatible
or irregular
application,
which may
increase risk
of roll-out.
NO.
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
8
All installation of CB Anchors MUST be performed by a Competent or
Qualified Person, or by a Guardian Fall Protection certified installer.
Refer to Guardian’s “Absorbinator” instructions for information regarding
the use of CB Anchors in combination with horizontal lifelines.
!
WARNING
“Absorbinator”
Shock Absorber