Qualcraft Tool Lanyard with Mini Carabiner - Manual (Page 2)

Installation and Use:
1. Pull rope loop end through applicable tool.
2. Pull carabiner end through rope loop, and cinch lanyard tight around
tool. NEVER attach tools in any other fashion. NEVER tie knots with
Guardian Tool Lanyards.
3. Attach carabiner to compatible harness web strap. Carabiner gate must
be fully closed.
4. Ensure no risk exists for carabiner to disconnect from harness, or for
tool to disconnect from lanyard.
Date of First Use: ___ /___ / 20___
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
ti
on
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
85020 (Rev. E)
Inspection:
Record the Date of First Use in this instruction manual and on the inspection grid label on equipment. The lifetime
expectation of Guardian Tool Lanyards is a maximum 5 years. Remove Guardian Tool Lanyards from service 5 years after Date
of First Use, or, if Date of First Use is not recorded, from Manufacturing Date.
Prior to EACH use, inspect Guardian Tool Lanyards for deficiencies including, but not limited to, corrosion, fraying, broken
stitching, bird-caging, pits, burrs, rough surfaces, sharp edges, rust, paint buildup, excessive heating, alteration, and missing
or illegible labels. Ensure carabiner gate fully opens and closes; gate must hold in closed position until compressed, or for
#10725, until unscrewed and compressed. IMMEDIATELY remove from service if defects or damage are found.
Every 6 months, a Competent Person other than the user must inspect Guardian Tool Lanyards. Competent Person
inspections must be recorded in inspection log in these instructions and on equipment inspection grid label. The Competent
Person must sign their initials in the box corresponding to the month and year of inspection.
Inspection Log
1.
2.