Qualcraft Wind Hook Accessory Kit - Manual (Page 2)

WALL JACK
MODEL #2601, #2602
COSNTRUCTION
PRODUCTS
Model 2601 Wall Jack - Instructions
Capacity: The wall jack when used in conjunction
with poles made of 2”x 4”s measuring 1 1⁄2”x 3 1⁄2”
clear straight grained fir wood, free from all knots or
defects has the capacity to lift 100 pounds.
Step #1: Select proper length pole: To determine
length of 2”x 4”pole use the following chart:
Wall Size: Minimum length pole
8 ‘ 12 ‘
8’6” 13’
9’ 13’6”
9’6” 14’6”
10’ 15’6”
10’6” 16’
Step #2: Mount wall jack onto the 2”x 4” fur pole by
sliding the wall jack up from the bottom of the pole
sliding the 2 x 4 through the first spring mechanism,
then continuing through the second spring mecha-
nism and resting behind the pin & roller at the bot-
tom of the wall jack.
Step #3: Place the wall hook under the top of the
wall section to be lifted.
Step #4: With the 2 x 4 pointing upwards, secure a
small piece of 2 x 4 behind the bottom of the pole to
prevent pole from kicking out.
Step #5: Place a second wall jack at the opposite
end of the wall as outlined in steps 1 through 4.
Step #6: Insert a 3⁄4” or 1” pipe into the handle re-
ceptacle and elevate the wall by moving the pump
mechanism up and down. Raise both jacks togeth-
er.
Step #7: After securing upright wall, remove wall
jack and pole.
Customer Support and Ordering Information
781-344-1000 • www.qualcraft.com