Qualcraft HitchClip Bunk Jack - Manual

Bunk Jack
Part #: 10573
Materials: aluminum.
Compliant with all applicable OSHA 1910 and 1926 regulations.
Bunk Jacks are specially designed to be utilized during
construction to accommodate a full bunk of plywood, or
to create a rooftop workstation, and can be adjusted to fit
a 6/12-12/12 pitch..
Maximum weight per pair of Bunk Jacks: 4,000 lbs.
(including all workers, tools, and equipment).
UPC-A Code: 672421105734
Custom configurations not available. Not repairable.
Contact customer service for details.
Installation and Use:
Locking Pin
Plywood
Location
Headpin
(2) Bunk Jacks required to receive up to 66 sheets of
½” CDX plywood. (1) HitchClip™ required per (1) Bunk Jack.
Q
ua
lc
ra
ft
In
du
st
rie
s
6
0
M
ap
le
S
t.
, P
.O
. B
ox
3
6,
M
an
sf
ie
ld
, M
A
0
20
48
ph
on
e:
(
80
0)
2
31
-5
64
7
w
w
w
.q
ua
lc
ra
ft
.c
om
1. Install all necessary HitchClips™ according to manufacturer’s
instructions. When used with Bunk Jacks, recommended spacing
between HitchClips™ is 6’.
2. Insert Bunk Jack Headpin into HitchClip™ key hole attachment
point from top to bottom, and ensure Bunk Jack fully locks into
place. HitchClip™ and Bunk Jack must be perpendicular to leading
edge of fall hazard.
3. Adjust Bunk Jack so that platform staging will lie flat when
installed. Secure and lock Bunk Jack with provided Locking Pin.
4. Place plywood across Bunk Jacks.
Instructions