ATTO Technology FastStream SC 5700 - Manual (Page 12)

7
ATTO Technology Inc. FastStream SC Installation and Operation Manual
1.3 FastStream SC 5700 Physical Attributes
The ATTO FastStream SC 5700 is a Fibre Channel to Fibre Channel storage appliance which can be seamlessly
integrated into a new or an existing storage environment.
The ATTO FastStream SC 5700 is available in an
industry-standard 1U form factor for easy integration
into industry-standard racks.
For installation instructions, refer to
Install the
FastStream Storage Controller on page 9.
Dimensions
Width: 17 inches
Length: 8.94 inches
Height: 1.7 inches (1U)
Weight: approximately 8 pounds
Cooling and airflow
Operating Temperature: 0°-40° C external
Humidity: 10-90% non-condensing
Airflow: air enters through slots on the right of the
rear panel and exits through slots on the left of the rear
panel.
CAUTION CAUTION
Do not block the enclosure’s vents. The
FastStream does not allow data transfer if
overheating occurs.
Power
Input voltage: 100-240VAC, 1.7-.7A, 50-60 Hz
Battery-backed event log: A rechargeable Lithium
ion battery cell holds the event log memory for up to 30
days. If the FastStream has been disconnected from
power, recharging begins automatically when power is
restored to the system. The battery is fully charged
after 36 hours of continuous power application.
WARNING WARNING
Risk of explosion if battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
Fibre Channel ports
The four independent 4-Gigabit Fibre Channel ports
connect the FastStream to either a Fibre Channel
Fabric or Fibre Channel Arbitrated Loop using optical
SFP connectors and multimode fiber optic cable.
Make sure all cables are anchored securely at both
ends with the proper connectors.
Ports 1 and 2 connect to the host computer; ports 3
and 4 connect to devices (see
Exhibit 1.3-1 ).
Management ports
The 10/100 base T Ethernet port is accessible from
the RJ45 connector and supports local diagnostics.
The RS-232 serial port provides
support for remote monitoring and
management using a DB9 connector.
The baud rate is programmable and
preset at the factory to 115200 bps.
Reset/restore factory default
switch
To reset the FastStream, briefly insert a tool in the hole
in the back panel.
To restore factory defaults, insert the tool in the hole in
the back panel for more than four seconds until the
green Ready LED blinks.
LED indicators
The LED indicators can be viewed from the back or the
front side of the FastStream. See
Exhibit 1.3-2 and
Exhibit 1.3-3 .
LEDs on the connector side are:
A bicolor Ready/Fault LED lights green to indicate
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
Embedded in the Ethernet port connector: a
lighted green LED shows a valid link; off indicates that
no link is present. A separate blinking yellow LED
indicates activity.
Fibre Channel port: A lighted green LED indicates
link; off means no link. A separate green LED indicates
activity if it is lit, no activity if it is off.
1
9
8
7
6
5
4
3
2 RX
TX
GND