Ramsey Winch ATV-2500 (W_Brake) - Manual (Page 9)

Installing the Rocker Switch
For clarification, see wiring schematic on pages
6-7.
1. Install green Wire Connector (item #18-20) to
green wire on Rocker Switch (item #17) and
black Wire Connector (item #18-19) to black wire
on Rocker Switch, as shown at right.
2. The Rocker Switch assembly (item #17) will be
assembled with the two halves of the housing
already attached. Install the Mounting Bracket
(item #18-8) using (2) #6 screws (item #18-12)
and shake-proof washers (item #18-18). See
figure below. Tighten securely.
Do not overtighten.
3. Install (2) Handle Bar Clamps (item #18-2)
around ATV handle bars at a convenient location.
Use a 3/4” long #10 screw (item #18-11) and #10
locknut (item #18-3) to secure them. See figure
below and at right. Secure loosely, do not
tighten.
9