Ramsey Winch ATV-3000 W_MINI ROCKER SWITCH - Manual (Page 14)

14
Installing the Rocker Switch
For clarification, see wiring schematic on
pages 8-9.
1. Install green Wire Connector (item #16-
20) to green wire on Rocker Switch (item
#12) and black Wire Connector (item
#16-19) to black wire on Rocker Switch,
as shown at right.
2. The Rocker Switch assembly (item #12)
will be assembled with the two halves of
the housing already attached. Install the
Mounting Bracket (item #16-8) using (2)
#6 screws (item #16-12) and shake-
proof washers (item #16-18). See
figure below. Tighten securely. Do
not overtighten.
3. Install (2) Handle Bar Clamps
(item #16-2) around ATV handle
bars at a convenient location. Use
a 3/4” long #10 screw (item
#16-11) and #10 locknut (item
#16-3) to secure them. See figure
below and at right. Secure loosely,
do not tighten.
16-8
15
16-18
16-12
16-10
16-17
16-7
16-3
16-2
16-11
16-3
NOTE:
LONGER SCREW
16-11