Ramsey Winch 130K WILDCAT WINCH User Manual
Page 20
DISASSEMBLY OF OUTPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see below). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below.
6. Carefully drive roll pin #305 into carrier pin #306 so that it is captured within carrier pin #306
but not touching the opposite side of the output carrier #301.
7. Tap carrier pin #306 to remove it from the output carrier #301.
8. Slide the planet gear #302 and the (2) thrust washers #308 from the carrier assembly #301.
Bearings #304 may then be removed.
9. Remove the roll pin #305 from the carrier pin #306.
10. Repeat this process for the two remaining gears in the carrier.
307
301
306
308
305
302
304
308
303
ITEM QTY
PART
NO
DESCRIPTION
301
1
317027
OUTPUT CARRIER
302
3
334229
PLANET GEAR
303
1
357538
OUTPUT SHAFT
304
9
402144
NEEDLE BEARING
305
3
470036
ROLL PIN
306
3
470131
PLANETARY PIN
307
1
490069
RETAINER RING
308
6
518076
THRUST WASHER
18