Ramsey Winch DC-200 SERIES LEVER - Manual (Page 15)

13
11. Check cover bushing (item #30) for signs of wear.
Replace if necessary by removing old bushing and
pressing new bushing into place.
13. Check gears of spur gear shaft assembly for signs
of wear, replace if necessary. Press old gears
from shaft (item #22). Tap key (item #20) into
keyway of shaft (item #22). Press shaft through
gears so that gears are centered on shaft and key.
14. Apply grease to end of shaft, opposite gear. Apply
grease to bushing in gear housing (Item#16). Place
greased end of shaft through spacer (item #74) and
bushing in gear housing (item #16). Place gasket
(item #51) onto gear housing cover (item #7). Apply
grease to gear end of shaft and bushing in cover.
Place cover onto shaft and secure to housing with
fi ve (item #33) capscrews at fi ve lower holes.
RE-ASSEMBLY
12. Check pinion gear on motor for signs of
wear. If necessary replace motor (item
#57).