Ramsey Winch DC-200 SERIES RAM-LOK - Manual (Page 18)

16
15. Place winch, with gear housing cover down, on work
bench. Drum shaft should be in vertical position. Slide
thrust washer (item #69) over drum shaft and slide
downwards until washer rests on gear housing. Set
springs (item #66) and drag brake disc (item #42) into
pockets of gear housing. Grease bushings in drum
(item #10). Slide drum assembly onto drum shaft with
drum jaws upward.
16. Slide thrust washer (item #70) over end of drum
shaft. Press drum (item #10) downward to compress
drag brake springs in gear housing.
Insert keys (item #47) into keyways with sharp edge of
keys pointing outward and notched end of keys up -
ward. A rubber or brass mallet will be needed to gently
tap keys into position.
Apply grease to keys and end of shaft. Place jaw
clutch (item #7) over end of shaft and slide jaw clutch
over keys. Set clutch housing (item #17) over end of
drum shaft. Pull jaw clutch (item#7) upward, toward
clutch housing, enough to allow yoke, in clutch hous-
ing, to fi t properly in groove around jaw clutch.